Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
POSSIBLE
PROBLEM
CAUSE
String is
welded to
itself.
Not enough
string on
String will not ad-
spool.
vance when using
String is
the bump-feed head.
worn too
short.
String is
tangled on
spool.
Grass wraps around
Cutting tall
shaft housing and
grass at
string head.
ground level
Battery is
not secure.
Motor fails to start
Battery is
when switch trigger
not charged.
is depressed.
Shaft not
connected
completely
* If the fault is not solved, you must go to your distributor and/or nearest Authorized
Technical Service.
SOLUTION
Replace string.
Install more string. Refer to string re-
placement earlier in this manual.
Pull string while pressing line release
button.
Remove string from spool and rewind.
Refer to string replacement earlier in this
manual.
Cut tall grass from the top down to
prevent wrapping.
To secure the battery pack, make sure
the latch on bottom of the battery pack
snaps into place.
Charge the battery pack according
to the instructions included with your
model.
Make sure lower shaft is fully seated in
shaft coupler on upper shaft and secure
shaft coupler.
Technical Data
PROPERTY
Model
No load speed
Cutting head
Cutting Line Diameter
Cutting Path Diameter
Battery pack
Charger
Weight (without battery pack)
Measured sound pressure level
Measured sound power level
Guaranteed sound power level
Vibration
VALUE
82TX10
4500-5500-6500-7000 /min
Bump feed
2 mm
40 cm
82V220G/82V430G/
82V220/82V430
82C2/82C6
4.7 kg
＜ 96 dB(A), K
L
=3 dB(A)
PA
PA
＜ 93 dB(A)
L
WA
96 dB(A)
2
2
< 2.5 m/s
, k=1.5m/s
11
cramer.eu
EN
GB
Publicité
