Cramer 82TX10 Mode D'emploi page 10

ADVANCING LINE (see Figure 6)
While the string trimmer is operating, the cutting line gets worn down and
becomes shorter. This trimmer is equipped with bump feed line advancement,
which advances additional line once the head is bumped on the ground while
rotating. The cutting blade will cut the line to keep an accurate cutting swath.
Cutting Tips (see Figure 7)
• Keep the trimmer tilted toward the area being cut; this is the best cutting
area.
•
The trimmer will cut better when moved from left to right across the area
to be cut; it is less effective when moved from right to left.
•
Use the tip of the cutting line to do the cutting; do not force cutting head
into uncut grass.
• Wire and picket fences cause extra cutting line wear, even breakage. Stone
and brick walls, curbs, and wood may wear cutting line rapidly.
•
Avoid trees and shrubs. Tree bark, wood moldings, siding, and fence posts
can easily be damaged by the cutting line.
LINE CUT-OFF BLADE (see Figure 8)
This trimmer is equipped with a line cut-off blade on the grass deflector. For best
cutting, advance line until it is trimmed to length by the line cut-off blade. Advance
line whenever you hear the engine running faster than normal, or when trimming
efficiency diminishes. This will maintain best performance and keep line long
enough to advance properly.
WARNING!
When servicing, use only identical replacement parts. Use of any
other parts may create a hazard or cause product damage.
WARNING!
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance.
Maintenance
Before each use, inspect the entire product for damaged, missing, or loose parts
such as screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged parts are replaced.
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING!
Do not at any time let brake fluids, gasoline, petroleum based
products, penetrating oils, etc. come in contact with plastic parts.
They contain chemicals that can damage, weaken or destroy
plastic.
WARNING!
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance.
Only the parts shown on the parts list are intended to be repaired or replaced by
the customer. All other parts should be replaced at an Authorised Service Centre.
SPOOL REPLACEMENT (see Figure 9-10)
Use original manufacturer's replacement cutting line for best performance.
•
Remove the battery pack.
• Push in tabs on both sides of the spool cover.
•
Remove the spool cover and the old spool.
• To install the new spool, make sure the cutting line is captured in the
slot on the new spool. Make sure the end of the cutting line is extended
approximately 15cm beyond the slot.
• Install the new spool so that the cutting line and the slot are aligned with
the eyelets in the cutting head. Thread the cutting line through the eyelets.
•
Pull the cutting line extending from the cutting head so the cutting line
EN GB
9
cramer.eu