Publicité
Les langues disponibles
Les langues disponibles
01
02
04
5.5 - Setting force on closure: "RDC" function
Caution! - The "RDC" function level can only be personalised after programming the limit position values "0" and "1".
01. Use the Up or Down button to move the awning to the point of mid-travel.
02. Press and hold the Up pushbutton until the aw ning reaches limit position "0" (do not release the button).
03. Then, with the Ascent button still pressed, press the Descent button the number of times as the level to be selected (press each time for 1 second, with a pause
of 1 second before pressing again). With the Up button still pressed, wait until the awning completes the same number of movements (in the down direction) as
the new level set. The levels available are:
level 1 = maximum force (factory setting.) / level 2 = medium force / level 3 = minimum force
04. Then release the Up button.
01
02
5.6 - Tensioning the fabric: "FRT" function (position "2")
This function is used to tension the awning canvas when open. The function is activated by programming position "2" in Era Star T.
During use of the automation, when the awning opens, the motor moves it first to position "1" and then immediately tensions the canvas by automatically activating a
short up movement to position "2".
Caution! - The "FRT" function level can only be set after programming the limit position values "0" and "1".
• To activate the "FRT" function
01. Use the Up or Down button to move the awning to the point of mid-travel.
02. Use the Down button to move the awning to position "1".
03. Press and hold both the Up and Down buttons until the awning performs a short up movement and then release the buttons.
04. Use the Up button to close the awning by a few centimetres, until the canvas can be seen to be adequately tensioned (this will be position "2").
05. Press and hold both the Up and Down buttons until the awning performs a short up movement and then release the buttons.
01
02
04
03
"0"
05
"1"
5
sec.
03
x 1 = maximum force /
x 1 = forza massima /
"0"
x 2 = forza media /
x 2 = medium force /
x 3 = medium force /
x 3 = forza minima /
"1"
"2"
"2"
(1)
1
5
sec.
2
03
1
5
sec.
05
1
(1)
5
sec.
THE
END
1/2 /3
04
?
THE
END
English – 5
THE
END
Publicité
