Adjusting The Battery Tray; Ae-5L Forward/Reverse Esc With Drag Brake - Horizon Hobby Axial WRAITH 1.9 RTR Manuel D'utilisation

EN

ADJUSTING THE BATTERY TRAY

M3x8mm (x4)

AE-5L FORWARD/REVERSE ESC WITH DRAG BRAKE

SETUP
Throttle calibration should not be needed out of the box. However, in order
to make the throttle range of different transmitters, the calibration of the
ESC is necessary:
• Mount the ESC in an area that is well ventilated and isolated from
vibration and shock.
• Connect the ESC motor wires to the motor red-to-red and black-to-black.
• Plug the receiver into the throttle channel of the receiver.
• Before plugging the battery into the ESC, make sure your transmitter is
on and the throttle trim is set to zero.
• Connect the battery to the ESC. The vehicle will be powered on when the
battery is connected.
CAUTION: Keep all body parts and loose clothing away from any
moving parts while the battery is connected to the ESC.
CAUTION: Always connect the ESC only to a proper power
source that has the correct voltage and polarity. Incorrect
voltages or reversed polarity will damage the ESC. Damage to the ESC
caused by improper voltage or polarity is not covered under warranty.
• Test forward and reverse control using the transmitter.
To calibrate the ESC:
• Power the transmitter on and set the throttle control to neutral.
• Connect the battery to the ESC and wait 3 seconds to let the ESC initiate
a self-test and automatic throttle calibration.
• The ESC is ready to run when a long beep sound is emitted from the motor.
• Always disconnect the battery when the vehicle is not in use.
NOTES
• The drag brake is set to 100% from the factory.
• The LiPo cut-off is set to "ON" from the factory.
Battery
Adjust the tray to the appropriate size to fi t the vehicle battery.
Suitable battery size range:
5.75" x .94-1.2" (147mm x 24-32mm)
ESC
Red
Black
ESC SPECIFICATIONS
Input Voltage
Size
Weight
Motor Limit
On-Resistance FET
Rated/Peak Current
Braking Current
BEC Voltage/A
PWM Frequency
ESC SOUND STATUS
1 Short Beep
2 Short Beeps
3 Short Beeps
1 Long Beep
10
Motor
To Receiver
Throttle Channel
2-3S LiPo, 5-9 Cells NiMH/NiCd
46.5mm x 34mm x 28.5mm
70g
12T 2S/18T 3S
.002
180A
90A
6.0V 3.0A Peak
1KHz
Battery is NiMH/NiCd
Battery is 2S LiPo
Battery is 3S LiPo
Self-test and throttle calibration
is OK and ESC is ready to run