Publicité
Les langues disponibles
Les langues disponibles
Assembly - Attaching the Fan Blades
1
Attaching the blade brackets
WARNING: Remove the rubber motor stops on the bottom of
the fan before installing the blades or testing the motor.
NOTE: Your fan features revolutionary advancements for quick
and easy blade installation, including an alignment post and
captive blade bracket screws.
IMPORTANT: The switch cup has an access hole (ZZ) to allow
the screwdriver to reach the screws in the blade bracket.
Position the blade bracket on the motor and tighten by
inserting the screwdriver through the access hole (ZZ).
□
Fasten the blade brackets (I) to the fan-motor assembly (F) by
inserting the alignment post into the slot on the bottom of the
motor and tightening the pre-installed blade bracket screws by
inserting a screw driver through the access hole (ZZ).
□
Repeat this step for the remaining blade assemblies by rotat-
ing the motor until the next blade bracket screw can be ac-
cessed through the access hole (ZZ) in the switch cup.
2
Attaching the fan blades
NOTE: Your fan features revolutionary advancements
for quick and easy blade installation.
NOTE: Your fan blades are reversible. Select the
blade side finish which best accentuates your decor.
□
Mount the fan blades (J) to the blade bracket (I) by aligning
the three key-slot holes in the blade (J) with the three posts
on the top of the blade brackets (I).
□
Hold the blade (J) close to the blade bracket (I) and press
the blade (J) down firmly. Ensure the key-slot holes are
properly seated on the blade arm posts.
□
While still holding the blade (J) down, firmly slide the blade
(J) away from the bracket (I) side until the blade (J) engages
in the locking mechanism (SS).
□
Make sure the locking mechanism (SS) at the rear of the
blade bracket (I) springs upward and butts against the edge
of the blade (J) indicating a secure connection.
□
Visually inspect the top of the blade bracket (I) to ensure the
locking mechanism (SS) is securely in place.
□
Repeat for the remaining blades (J).
F
I
ZZ
12
J
I
SS
Publicité
