Publicité
Les langues disponibles
Les langues disponibles
English
7. How to use the drill bit (taper shank)
and the taper shank adaptor.
(1) Install drill bit with taper shank in the
taper shank adaptor.
(2) Turn the power on and drill a base hole.
(3) After cleaning out dust with a syringe,
attach the plug to the anchor tip and
drive in the anchor with a manual
hammer.
(4) To remove the drill bit with taper shank,
insert a cotter into the slot of the taper
shank adaptor, place supports under the
rotary hammer and tap the cotter with
a manual hammer. (Fig. 12)
USING DRILL CHUCK, CHUCK ADAPTOR
Note that this machine can be used at "rotation only" if separately sold parts such
as drill chuck and chuck adaptor are attached. Use it with the selector lever positioned
at "rotation + hammering".
WARNING:
During operation, be sure to grip the handle and the side handle firmly to prevent
your body from swaying.
(1) Switching to "rotation + hammering"
For
switching
hammering",
procedures mentioned in [3. When
drilling at "rotation + hammering"] in
Page 12.
(2) Attaching chuck adaptor to drill chuck
(Fig. 13)
(a) Attach the chuck adaptor to the drill
chuck.
(b) The SDS max shank of the chuck
adaptor is equivalent to the drill bit.
Therefore,
procedure as [6. How to install tool]
in Page 10 for attaching and
detaching.
14
to
"rotation
follow
the
same
follow
the
same
Taper Shank Adaptor
Drill Bit
(Taper shank)
Fig. 11
Cotter
Fig. 12
+
Drill
SDS max
Chuck
Shank
Chuck
Adaptor
Fig. 13
Taper Shank
Adaptor
Support
Grip
Publicité
