Hotpoint HS68M8PCX/FR Mode D'emploi page 27

Fig. 1
Your new cooker comes with 2 chrome shelf supports packed in the oven with the shelves.
Note the top rods are longer then the bottom and the hooks are at the back of the oven. See fig. 1.
The top of the shelf support engage in slots in the side wall of the oven as in Fig. 2.
Once engaged at the top, then push the bottom rods into the lower slots in the oven side walls. Now allow the shelf supports to
lower slightly and engage. See Fig. 3
Partial and full extension sliding shelves facilitate the
handling of wire shelves and trays.
1. remove the side holder grills (Fig. 1)
2. remove the plastic protection from the sliding
shelves (Fig. 2).
3. Hang the upper part of the sliders on to the
holder grills. make sure the telescopic runners
can move freely to the front of the oven.
then press the lower part of the sliding
shelves firmly against the holder grill until
they click into place (Fig. 3).
4. refit the side holder grills to the cavity (Fig. 4).
5. put the accessories on the slider (Fig. 5, 6).
MOUNTING LATERAL GRIDS
MOUNTING THE SLIDING SHELVES (IF PRESENT)
Fig. 2
1
2
Fig. 1
Fig. 3
Fig. 5
27
Fig. 3
Fig. 2
Fig. 4
Fig. 6