Whirlpool ADN 203/2 CH Manuel D'instructions page 7

The temperature in the device compartment is controlled using the thermostat knob 2 (see fig.
1) by turning it to one side or the other. The temperature indication in digits is shown beside
the thermostat knob. When the door is closed, the temperature setting can be seen on the
thermostat indicator display 3 (see fig. 1, page 1). The numbers "0, 1, 2, 3, 4, 5" do not mean a
specific temperatures.
The temperature is regulated on the scale of five digits.
0 = Compressor is switched off WARNING! Electric current is not switched off.
1 = highest temperature (lowest cooling)
5 = lowest temperature (highest cooling)
THE TEMPERATURE IN THE DEVICE COMPARTMENT MAY VARY DEPENDING ON
AMBIENT TEMPERATURE, THE AMOUNT OF FOODSTUFFS, THE TEMPERATURE OF THE
FOODSTUFFS, AND HOW OFTEN THE APPLIANCE DOORS ARE OPENED AND CLOSED.
If the room is cool, the appliance cools less. The temperature in the appliance may
therefore rise. Use the thermostat wheel to set a lower temperature.
THE REFRIGERATOR COMPARTMENT DEFROSTS AUTOMATICALLY. Drops of ice that form on
the back wall of the refrigerator compartment thaw during the time the compressor is not
working and the thaw water runs down the thaw water runoff channel to the tray on top of the
compressor, where it evaporates.
REGULARLY CLEAN THE APPLIANCE.
Remember that before cleaning the back part of the appliance body you must
disconnect the appliance from the electrical energy supply socket by pulling
the plug out of the electricity outlet.
Protect the appliance inner surfaces and plastic parts from fats, acids and
•
sauces. In case of accidental spills – immediately clean with warm soapy
water or dishwashing detergent. Wipe dry inner and outer surfaces.
Regularly clean the hermetic gaskets of the doors. Wipe dry.
•
REGULARLY CLEAN THE THAW WATER CHANNEL SPACE WITH A SPECIAL
•
CLEANER 8 FOR THAT PURPOSE (see fig. 1, page 1).
At least once a year clean dust away from the back part of the appliance
•
body and the compressor.
cleaner may be used for cleaning.
DO NOT use detergents containing abrasive particles, acid, alcohol or benzene for cleaning
•
the appliance inner and outer surfaces. DO NOT use for cleaning cloths or sponges that have
coarse surfaces intended for scrubbing. Outer of the doors – glass – clean with agents
intended for glass cleaning.
IF THE APPLIANCE IS TO BE LEFT SWITCHED OFF FOR AN EXTENDED PERIOD, LEAVE ITS
•
DOORS OPEN.
OPERATION PROBLEMS AND THEIR SOLUTIONS. What if ...
The appliance is plugged in to the mains but it does not work and the electricity
•
supply voltage indicator is not illuminated. Check that your house electricity supply
installations are in order. Check that the plug is correctly inserted into the electricity supply
socket.
The noise has become louder. Check that the appliance is standing stable, on a level
•
place. To make it level, regulate the front feet. Check if the appliance is not touching any
TEMPERATURE REGULATION
DEFROSTING, CLEANING AND CARE
A soft brush, electrostatic cloth or vacuum
6