Whirlpool ADN 203/2 CH Manuel D'instructions page 6

Do not cover the ventilation holes at the top of the appliances – it must be a good air
•
circulation around the appliance. There should be a gap of at least 10 cm between the top of
the appliance body and any furniture that may be above it. If this requirement is not
followed, the appliance consumes more electrical energy and its compressor may overheat.
If the appliance is placed in a corner, a gap of at least 1 cm must be left between the
•
appliance body and the wall (see fig. 3, page 1).
The appliance must stand on a level surface and must not touch the wall. If necessary,
•
regulate the height of the appliance by adjusting the levelling feet: by turning them clockwise
– the front of the appliance rises, by turning them counter clockwise – it comes down. If the
appliance is tilted slightly backward – the doors will close by themselves.
Preparing the appliance for operation:
It is recommended to prepare the appliance for operation with a helper.
Remove package. Lift the appliance away from foamed polystyrene base.
•
The device must only be transported in its vertical position; do not tilt any more than 30°.
•
Therefore take out adhesive tapes from sides and simply lift the appliance up and take out
•
the board. Strip adhesive tapes off and open the door. Remove the spacer above the door.
When positioning the appliance in chosen location, it will move more easily into position if you
•
lift the front a little and incline it backward allowing it to roll on its casters. When placing,
moving, lifting the appliance, do not hold the door handles, do not pull the
condenser at the rear part of the refrigerator and do not touch the compressor unit.
Take two supports from the bag and insert them into the guides at the top back part of the
•
appliance (see fig. 2, page 1).
The appliance should not be connected to the mains until all packing and transport
•
materials aren't removed. Suitably dispose the packaging material.
Once the unit has been positioned, wait for about 30 minutes before it is connected to the
•
.
mains
If the device has been tilted more than 30° during transport, allow it to
•
stand in an upright position for at least 4 hours before it is connected to
the mains. If this is not done, the appliance compressor may fail.
THE APPLIANCE BASIC PARTS (see page 1. fig. 1)
On/ off switch for interior light
1
I -(ON) O –(OFF)
2 Thermostat knob
3 Thermostat indicator
Electricity supply indicator
When the appliance is connected to
4
the electricity supply, the green
indicator light is illuminated.
5 Interior light block (LED)
6 Fan. WARNING! The fan switches on and continuously operates!
7 Adjustable height shelves
8 Thaw water channel cleaner
Thermometer (in models ADN
202/1, ADN 202/2, ADN 230/1,
9
ADN 230/2 ADN 203/1, ADN
203/1S, ADN 203/2)
10 Condenser
11 Compressor
5