Publicité
Les langues disponibles
Les langues disponibles
VI. INSTALLATION:
1.
Remove factory front a-arm guard, if
applicable.
2. Fasten guard A1 or A2 to appropriate a-arm
using M6 screws (C1). Include the spacer
plate (B1) between the a-arm and guard as
shown in Figure 1. Do not fully tighten.
3. Align guard as needed. Tighten all fasteners to
torque specifications listed on page 2.
WARN INDUSTRIES
©2007 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
M6 Screws
PAGE 4
Figure 2
Figure 3
78469A1
Publicité
