Publicité
Les langues disponibles
Les langues disponibles
OPERATING THE SWASH
Special Mode Operations
NOTE: Do not sit on the seat when in Special Mode Operations. The process will
not work while the seat is occupied.
Seat Sensor Override
The Seat Sensor is activated at the factory by default. Completing the
following steps will bypass the body sensor located in the seat and allows
the wash functions and dry functions to operate without the sensor being
engaged. Use caution in this mode.
1. Unplug the Swash bidet seat.
2. Press the two Water Pressure/Dry Temp buttons (+ and –) and plug the seat
in while holding the two buttons down.
3. Keep holding the two Water Pressure/Dry Temp buttons (+ and –) down for
five seconds. A beep will sound, indicating that the Seat Sensor has been
overridden. To test that the procedure worked, press the Dry button. If
the Warm Air Dryer comes on without anyone sitting on the seat, you have
successfully overridden the Seat Sensor.
4. You can resume using the seat as normal.
5. To reactivate the Seat Sensor, repeat Steps 1-3.
Activating/Deactivating Silent Mode
By default, the Swash will beep to confirm commands from the control panel.
Follow the steps below to silence the beeping sounds.
1. Press and hold down the Rear Wash/Move button and the "–" Water
Pressure/Dry Temp button at the same time for four seconds.
2. A beep will sound, indicating that the Silent Mode has been activated.
3. To deactivate Silent Mode, repeat Steps 1-2.
18
Publicité
