Publicité
Les langues disponibles
Les langues disponibles
OPERATING THE SWASH
Using the SE400
NOTE: The wash functions will not work unless the sensor in the seat detects someone sitting down (with
the built-in skin conductivity sensor). To override the Seat Sensor, please see the instructions on Page 18.
Prepare for Wash
Sit on the seat to ensure skin-to-seat contact on
the Seat Sensor. Once contact is made the seat
will automatically perform many functions:
1. The seat will give an audible beep letting you
know the Seat Sensor has been engaged.
2. The water pressure indicator lights will come
on displaying the current setting.
3. If the bidet was set to Eco Mode, the seat
and water temperature will rise to the set
temperature settings.
16
Warm Water Wash
When ready to wash, press the "Rear Wash"
or "Front Wash" button on the control panel
one time to initiate a wash. The nozzle will
self-clean, extend into the toilet bowl, spray
for two minutes, turn off automatically, retract,
and self-clean once again.
1. Pressing the "Rear" or "Front" button a
second time while the wash is running will
cause the nozzle to oscillate forward and
backward, providing a wider range of
wash spray. Press again to cancel the
move function.
2. While washing, users can adjust the water
temperature, pressure, and nozzle position
settings, as well as initiate the massage
feature by following the notes on Page 15.
3. If you would like to stop the wash before
the two minute cycle ends, press the
"Stop" button to discontinue water flow.
4. After extended use the water may
decrease in temperature if a LOW,
MEDIUM, or HIGH water temperature
setting is selected. To regain warmer water,
stop all wash functions for three minutes to
allow the bidet to reheat the water.
Publicité
