Technibel Climatisation KPAV122C5TA Notice D'utilisation page 3

NAME OF PARTS AND OPERATION SELECTOR
INDOOR UNIT
3
4
2
1
1. Remote control unit.
2. Sensor: Detects the room temperature around the remote
control unit, the air conditioner is controlled accordingly.
3. Air outlet: Conditioned air is blown out of the air conditioner
through the air outlet.
4. Air intake: Air from the room is drawn into this section and passes
through air filter which removes dust.5.
receiver: This section picks up infrared signals from the remote
control unit (Transmitter).
6. Operation selector.
ON Position: In this position the air conditioner is operating
and controlled by the remote control unit.
Set the selector normally in this position.
OFF Position: Switch the selector to the off position if you
are not going to use the air conditioner for
a few days or longer.
WARNING
The OFF position does not disconnect the power. Use the
main power switch to turn off power completely.
CAUTION
TEST Position: This position is used only for servicing the
air conditioner, so don't leave the selector in
this position for normal operation.
7. OPERATION lamp: This lamp lights when the air conditioner
is running.
8. STANDBY lamp: This lamp lights
– During warm up period
– When the system is defrosting
– When the temperature selected on the remote control unit is
reached
This lamp switches off automatically
– At the end of defrosting period
– At the end of warm up period
To keep a constant room temperature, the air conditioner continues
to supply a gentle breeze during warm up or when the heating
operation is interrupted by the thermostat (heat pump version).
9. TIMER lamp: This lamp lights when the system is being
controlled by the timer.
COOL/DRY Models
5
COOL/FAN Models
9 7 5
COOL / DRY / HEAT Models
9 7 5
8
INSTALLATION LOCATION
G
We recommend this air conditioner to be installed properly
by qualified installation technicians in accordance with the
installation instructions provided with the unit.
Remote control
G Do not install this air conditioner where there are fumes
or flammable gases, or in an extremely humid space
such as a green house.
G
Do not install the air conditioner where excessively high
heat-generating objects are placed.
G Do not install the air conditioner where the atmosphere
is extremely damp or humid (e.g. greenhouse or laundry)
it could be wetted by drops of water (i.e. in laundries).
Avoid:
To protect the air conditioner from heavy corrosion, avoid installing
the outdoor unit where salty sea water can splash directly onto
it or in sulphurous air near a spa.
ELETRICAL REQUIREMENTS
G
Before installation, check that the voltage of the electric supply
in your home or office is the same as the voltage shown on the
nameplate.
G All wiring must conform to the local electrical codes. Consult
your dealer or a qualified electrician for details.
G Each unit must be properly grounded with a ground (or earth)
wire or through the supply wiring.
G Wiring must be done by a qualified electrician.
APPLICABLE ONLY FOR MODELS
GR/GRV18X - GR/GRV22X
If the air conditioner hasn't been used for a long
period, warm up the system, the power mains must
be turned on at least five (5) hours before operation.
3
WARNING
CAUTION
POWER MAIN SWITCH
EG
6
OFF
ON
TEST