Publicité
Les langues disponibles
Les langues disponibles
IV. GETTING STARTED
Before any intervention on product, ensure that switch is on the OFF position
and that tool's plug is disconnected from the mains power supply.
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage.
4.2- Before starting the machine - Connection
- This hedge trimmer may only be connected to single-phase 230V AC source.
Ensure that the voltage of the mains power supply matches the operating voltage
indicated on the tool's rating plate.
- Connect the power plug to the coupling of an appropriate extension cord.
- Form a loop with the extension cord, push it through the opening in the rear handle and
hook over the cable holder (8) (see Fig.2).
The Fig.2 shows an example of power cord affixed to the cable holder based on model
PRTH509A / RHK514856.
4.3- Starting the machine
- Switching on: press the on/off switch (4) of the front handle and the switch (5) of the rear handle with both
hands at the same time.
- Switching off: Release any one of the switches (4) or (5).
- The blade brake makes the blades stop immediately within 0.5s
Warning! The cutting blades continue to move for a few seconds after the hedge trimmer is switched off.
Wait until the cutting blades come to a complete standstill before placing the machine down
Caution! Do not touch the moving blades.
4.4- Rotating handle adjustment
Press on unlock button (9) and then rotate handle clockwise or anti-clockwise.
It is possible to adjust at 45 or at 90.
(only available on PRTH610A /
Fig.3
RHK514866)
Fig.2
Page 19 / 31
Publicité
