Benchmark 5073-359 Mode D'emploi page 50

LOCK-OFF AND TRIGGER SWITCHES
The grass trimmer is equipped with both a lock-o and trigger switch. To turn the
grass trimmer ON:
1. Press the lock-o switch (1) (Fig.11).
2. While continuing to press the lock-o switch, squeeze the trigger switch (2).
3. When the grass trimmer starts, release the lock-o switch while continuing to
squeeze the trigger switch. The grass trimmer will continue to run.
4. To turn the grass trimmer OFF, release the trigger switch.
NOTE: To restart the grass trimmer, press the lock-o switch and squeeze the
trigger switch.
REPLACING THE TRIMMER LINE SPOOL
WARNING: Remove the battery from the
tool before attempting to replace the
trimmer line spool.
As the trimmer is used, the line will automatically
be dispensed from the spool. In time, the line
supply within the spool will be depleted, making
it necessary to replace the spool with a new
prewound spool.
REMOVING THE OLD SPOOL
Press the spool locking buttons (1) into the
1.
spool housing (2) (Fig. 12).
NOTE: There are two spool locking buttons
located on opposite sides of the spool
housing.
2. While pressing both spool locking
buttons, pull the spool cap (3) out of the
spool housing (Fig. 13).
3.
Pull the empty spool (4) upward to remove the
spool and any remaining
trimmer line from the spool housing (Fig. 14).
Once the empty spool has been
4.
removed from the spool housing, use a
soft brush to remove any debris from
the spool housing.
19
Fig. 11
Fig. 12
Fig. 13
Fig. 14