Publicité
Les langues disponibles
Les langues disponibles
Never use a machine that has been modified in
any way from its original specification.
Never use the machine near explosive or flammable
materials.
Never use a machine that is faulty. Carry out
the safety checks, maintenance and service
instructions described in this manual. Some
maintenance and service measures must be
carried out by trained and qualified specialists. See
instructions under the heading
Maintenance.
Only use original spare parts.
Always ensure that ventilation openings are
kept clear of debris.
All covers, guards and handles must be fitted
before starting.
Only use the machine in daylight or in other
well-lit conditions.
Never use the machine in bad weather, for
instance in fog, in rain, damp or in wet
locations, strong winds, intense cold, risk of
lightning, etc. Extremely hot weather may
cause overheating of the machine.
Always use common sense
It is not possible to cover every conceivable
situation you can face. Always exercise care and
use your common sense. Avoid all situations which
you consider to be beyond your capability.
If you still feel uncertain about operating
procedures after reading these instructions, you
should consult an expert before continuing.
ADDITIONAL SAFETY
INSTRUCTIONS FOR BATTERIES
AND CHARGERS
Use only batteries and
chargers applicable for this
Never attempt to open for any reason.
Do not store in locations where the temperature
may exceed 40 °C.
Charge only at ambient temperatures between
4 °C and 40 °C.
Do not cause short circuits. If connection is
made between the positive (+) and negative (-)
terminal directly or via accidental contact with
metallic objects, the battery is short circuited
and an intense current will flow causing heat
generation which may lead to casing rupture or fire.
Do not heat. If batteries are heated to above
100 °C, sealing and insulating separators and other
polymer components may be damaged resulting in
electrolyte leakage and/or internal short circuiting
leading to heat generation causing rupture or file.
Moreover do not dispose of the batteries in fire,
explosion and/or intense burning may result.
Under extreme conditions, battery leakage may
occur. When you notice liquid on the battery,
proceed as follows:
machine.
Carefully wipe the liquid off using a cloth. Avoid
skin contact.
In case of skin or eye contact, follow the
instructions below:
Immediately rinse with water. Neutralize with a
mild acid such as lemon juice or vinegar.
In case of eye contact, rinse abundantly with
clean water for at least 10 minutes.
Consult a physician.
Ne pas brûler le chargeur et le
Ne pas exposer le chargeur et
le pack-batteries à des
supérieures à 50 °C.
Ne pas exposer le chargeur et
le pack-batteries à l'humidité.
Chargers
Never attempt to charge non-rechargeable
batteries.
Have defective cords replaced immediately.
Do not expose to water.
Do not open the charger.
Do not probe the charger.
The charger is intended for indoor use only.
CHARGING AND INSERTION OR
REMOVAL OF BATTERY
Note: if the battery does not
fit properly, disconnect it and
battery pack is the correct
model for this charger as
shown on the specification
chart. Do not charge any
other battery pack or any
battery pack that does not
securely fit the charger.
1.
Frequently monitor the charger and battery
pack while connected
2.
Unplug the charger and disconnect it from the
battery pack when finished.
3.
Allow the battery pack to cool completely
before using it.
4.
Store the charger and battery pack indoors, out
of reach of children.
NOTE: If battery is hot after
continuous use in the tool,
allow it to cool down
to room temperature before
charging. This will extend
pack-batterie
températures
confirm that the
the life of your
batteries.
27
Publicité
