SOUNDMASTER ICD1050 Mode D'emploi page 32

FM radio mode receives analogue radio from the FM band and
displays RDS (Radio Data System) information about the station
and where broadcast.
•
Automatic station storage
To full scan, press "INTRO" remote key. The frequency display starts to run and scans
the FM full band. The found stations will be stored to the FM pre-sets.
•
Automatic and manual channel search
To automatic tune, press and hold "
key. The frequency display starts to run and scans the FM band and stops at the next
station.
To manual fine tune press the "
steps.
•
Presets storing and recall
Storing and recall of FM stations to preset is same functionality as described in the internet
radio section.
•
Now playing information
While the stream is playing, the screen shows its frequency, or if RDS signal is available, station
name and any further RDS information such as program name, title and other details. Stereo
broadcasts are indicated with an icon at the bottom of the screen. To view further information,
press Info button on the radio.
Each time you press "INFO" button on the radio, another set of information is displayed, cycling
through Radio text, program type, frequency and today's date
SETTINGS
Scan settings
•
Choose FM at first, it will go to a specific station playing. Then press "MENU" on the radio to get
above table.
By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio
(hiss) from weak stations. To change the scan settings to stop only at stations with good signal
strength, select "Yes" after choosing Strong station only.
•
Audio settings
All stereo stations are reproduced in stereo. For weak stations, this may result in a poor signal-
to-noise ratio (hiss). To play weak stations in mono, select FM weak reception: Listen in mono
only and then YES.
FM
" or " " button on panel or "P+" or "P-" remote
" or " " remote key. The unit search in 0.05 MHz
12
ICD1050 / English Instruction Manual
.