System Reset; Parking Brake Inhibit - Audiovox VME 9425 Mode D'emploi

System Reset

To correct a system halt or other illegal operation, use the tip of a pen to press the reset
button located on the front bottom-left corner of the unit behind the protective cover. After a
system reset, the unit restores all factory default settings.
NOTE: If the unit is reset while a DVD is playing, the DVD resumes play once the reset
is complete.
Image/Display Settings
Video Output Modes
The following table shows the video output mode for each playing source.
Playing Source
AM/FM TUNER
DVD
AUX IN
*CVBS – Composite Video Baseband Signal
Picture Adjustment
To adjust monitor display settings, perform the following steps:
1. Press and hold the NAV button on the monitor to display the picture adjustment menu.
The "BRIGHT" bar is highlighted in yellow.
2. Turn the rotary encoder to adjust the brightness setting level.
3. Press and hold the NAV button again. The "CONTRAST" bar is highlighted in yellow.
4. Turn the rotary encoder to adjust the contrast setting level.
5. Press and hold the NAV button again to exit the picture adjustment menu.

Parking Brake Inhibit

When the pink "Parking" wire is connected to the vehicle Parking Brake circuit, the front
TFT monitor will display video when the Parking Brake is engaged. (When the pink wire is
grounded via the Parking Brake circuit, video will be displayed.)
Video Output Modes
Video Output Modes
RGB Mode
YCbCr Mode
CVBS Mode
78