GYS Toparc MT-125 Mode D'emploi page 9

SET UP
TORCH CONNECTION REQUIREMENT
The cutting machine must be switched off.
TORCHES EQUIPMENT
The torch must be fitted with the appropriate consumables, selected based on the application and selected current.
Using the wrong consumables will result in poor cutting, excessive use of consumables and possibly prevent the machine from working.
MT-125 – CUTTING-GOUGING :
039322 (x1)
45A
039230 (x1)
Shield
039247 (x1)
Shield
039254 (x1)
Shield
MT-125 / AT-125
PRECISION CUT
039315 (x5)
45A
039162 (x5)
45A
039216 (x1)
039179 (x5)
65A
Protective
shroud
039186 (x5)
85A
Tailpipe
029193 (x5)
105A
039223 (x1)
039209 (x5)
125A
Protective
shroud
Tailpipe
039261 (x5)
039216 (x1)
65-85A
Tailpipe
Protective
shroud
Insert the torch connector (A) in the female connector (E) and screw the
part B. Make sure the torch is tight enough.
To remove the torch, unscrew as shown below.
039155 (x5) 039131 (x1)
Electrode Di user
039155 (x5) 039148 (x1)
Electrode Di user
039155 (x5) 039131 (x1)
Electrode Di user
EN
039506 - 6 m
039513 - 12 m
039506 - 6 m
039513 - 12 m
039506 - 6 m
039513 - 12 m
9