Aqua Medic AC Runner 3.2 Mode D'emploi page 6

Fig. 2: AC Runner 3.2
1. Rubber feet
2. Holding plate
3. Pump motor
4. Rear bearing
5. Impeller rotor
6. Housing's sealing
7. Pump lock
8. Seal for pressure connections
9. Seal for pressure connections
Fig. 3: AC Runner 5.2 + 9.2 + 12.2
1. Rubber feet
2. Holding plate
3. Pump motor
4. Rear bearing
Available spare parts: Please refer to www.aqua-medic.de.
The pump may only be operated with
is 2 m.
Safety advices
The pump is constructed for indoor aquarium use only. Before working on the aquarium, the
power plug must be disconnected from the mains. The connection cable and the power plug must
not be changed. If the power cable is damaged, the pump must be scrapped.
10. Adhesive sleeve
11. Adhesive sleeve
12. Hose connection pressure side
13. Hose connection suction side
14. Union nut pressure side
15. Union nut suction side
16. Filter basket
17. Sealing plug
5. Impeller rotor
6. Housing's sealing
7. Pump lock
8. Seal for pressure
connections
water. An installation out of water is possible. The max. water depth
9. Adhesive sleeve
10. Hose connection
11. Union nut
12. Filter basket (only AC Runner 5.2)
6