Publicité
Les langues disponibles
Les langues disponibles
Lawn mower
The warning indicator (error LED) is found below the
battery lid.
Problem
Error LED flashes.
The product does not
operate correctly.
Error LED flashes.
The product stops.
Other errors.
Introduction
WARNING:
during transport and storage turn the safety
key to 0, remove the battery and wait a
minimum of 5 seconds.
To set the product in transport position
1. Push the height adjustment bail with your foot. (Fig.
38)
18
Number
of flashes
Cause
on the er-
ror LED
The blade is blocked.
5
The motor speed
drops too much, and
the motor stops.
The motor control is
10
too hot.
Battery connector
0
failure.
There is overload in
3
the motor.
8
The battery is weak.
Battery error or no
9
signal from battery.
Incorrect start pro-
cedure. The motor
12
brake handle has
been engaged before
the motor starts.
If other errors occur, turn the safety key to 0, remove the battery and speak to your Husqvar-
na servicing dealer.
Transportation, storage and disposal
To prevent accidental start
Solution
Turn the safety key to 0 to prevent accidental start. Re-
move the battery and wait a minimum of 5 seconds. Re-
move possible obstacles and make sure that the blade
can rotate freely. If the problem continues, speak to your
Husqvarna servicing dealer.
Increase the cutting height. Refer to
height on page 13 .
Stop the motor and wait until it has become cool.
Examine the battery connector.
Increase the cutting height. Refer to
height on page 13 .
Charge the battery. Refer to
page 14 .
Put the battery in the product correctly and examine the
battery connector. If the error LED on the battery flashes.
Battery on page 17 .
Refer to
Release the motor brake handle and wait approximately
5 seconds. Push the motor brake handle down again to
start the product.
2. Pull up the handle and pull out the height adjustment
bail from the groove.
3. Fold the handle forward until it has reached the end
position. (Fig. 39)
4. Fold the height adjustment bail towards the cutting
cover. (Fig. 40)
5. Release the handle knobs. (Fig. 41)
6. Fold the upper handle rearwards. (Fig. 42)
To set the cutting
To set the cutting
To charge the battery on
1869 - 005 - 31.08.2023
Publicité
