Husqvarna LB 144i Manuel D'utilisation page 15

1. Release the motor brake handle to stop the motor.
(Fig. 30)
2. Open the battery lid and turn the safety key to 0.
(Fig. 31)
3. To remove the battery, push the 2 release buttons
and pull out the battery. (Fig. 32)
4. Charge the battery if it is weak. For more
information, refer to
14 .
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
1869 - 005 - 31.08.2023
To charge the battery on page
Before you do
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
• Keep the cutting cover clean. Buildup from grass
and dirt on the inner side of the cutting cover can
decrease the cutting result. Refer to
product on page 16 .
Maintenance
For more detailed information, refer to
www.husqvarna.com.
Maintenance schedule
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Safety on page 8 .
To clean the
15