Husqvarna LB 144i Manuel D'utilisation page 13

Introduction
WARNING:
product, read the safety chapter.
WARNING:
during assembly, turn the safety key to 0,
remove the battery and wait at minimum 5
seconds.
To assemble the handle
1. Fold the upper handle forward.
2. Tighten the handle knobs. (Fig. 19)
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.
To set the product in operation position
1. Assemble the handle. Refer to
handle on page 13 .
2. Adjust the handle height. Refer to
handle height on page 13 .
CAUTION:
too much tension in the cables. Too much
tension can cause damage to the cable if
the handle is folded into transport position.
1869 - 005 - 31.08.2023
Assembly
Before you assemble the
To prevent accidental start
Operation
Before you operate the
To assemble the
To adjust the
Make sure that there is not
3. Pull the handle rearward until it is in the end position.
4. Fold down the height adjustment bail and put it into
the groove. (Fig. 20)
5. Press down the height adjustment bail with your foot.
(Fig. 21)
To adjust the handle height
1. Make sure that the height adjustment bail is in the
groove. Press down the height adjustment bail with
your foot, if the height adjustment bail is not put in
the groove. (Fig. 21)
2. Press in the height adjustment bail with your foot.
3. Put the handlebar in the correct position and release
the handlebar. (Fig. 22)
WARNING:
unless the handle is fully folded up and set
in one of the applicable height positions.
To adjust the handle height on page
Refer to
13 .
To set the cutting height
The cutting height can be adjusted in 6 different steps.
1. Move the cutting height lever rearward to increase
the cutting height. (Fig. 23)
2. Move the cutting height lever forward to decrease
the cutting height.
CAUTION:
too low. The blades can hit the ground if the
surface of the lawn is not level.
Battery
WARNING:
you must read and understand the safety
chapter. You must also read and understand
the operator's manual for the battery and the
battery charger.
Keep the battery and the battery charger in correct
ambient temperatures.
Operation of the bat-
tery
Do not operate the product
Do not set the cutting height
Before you use the battery,
Ambient temperature
5 °C - 40 °C
13