Before first use
Important! Allow the appliance to stand upright for 8 hours before
connecting to a mains outlet for the first time, in order to allow the
refrigerant to settle.
The maximum load for a shelf (9) is 40kg.
The appliance can be connected to a supply with system impedance no
more than 0.243 Ohm. If necessary, please consult your supply
authority for system impedance information.
Cleaning
Unplug your appliance and remove any products to a suitable back-up
showcase before cleaning.
Take out all removable parts before cleaning.
Clean the inner compartment (12), equipment parts and casing (4 )with
dry cloth. Do not allow the control panel (7), power cord with plug (5),
ventilation openings (3), lamps (10, 13) or other electrical components
to become wet.
Never use corrosive detergents, wire brushes, or abrasive scourers to
clean your appliance.
Never use metal or sharp implements to remove debris.
Dry all surfaces thoroughly.
Use dry cloth to clean the gaskets and seals. Check them for debris to
ensure the doors (11) always close properly.
Do not remove or damage the rating label as it contains important data.
Replacing the lamps
Please do not replace the lamps (10, 13) yourself. Contact qualified
personnel for this purpose.
Note: the specification of replacement lamp should be the same as the
original one.
10
GB