Controller Operation Instrction
The front panel of the thermostat
1. LED display
2. SET button
3. buttons
Connect the power plug (4) with the mains outlet.
The showcase starts to work.
The thermostat (digital temperature controller) is located at bottom of the
appliance.
After a few seconds the LED display (12) shows the actual inner compartment (9)
temperature. The showcase automatically begins to cool down to the preset
temperature.
The factory pre-set temperature range is between 0°~ 8°C, dependent upon model.
Do not adjust this within the first 24 hours! After 24 hours adjust the temperature
in gradual stages, if necessary.
Temperature adjustment
PressS ET (13). The LED display (12) flashes. Select the desired temperature by
pressing
buttons (14) and press SET (13) again to save the settings.
The LED display (12) shows the actual inner compartment temperature. The
showcase automatically begins to cool down to the preset value.
Switching the lamp on/off
Press the ON/OFF switch I/0 (6) to switch on/off the lamp (11).
Locking the door
Insert the key into the lock (1) and turn 90° anticlockwise to lock the door (10).
Please double check and confirm that there is no person inside the appliance before
locking the door (10).
6
GB