Publicité
Les langues disponibles
Les langues disponibles
6. TROUBLESHOOTING GUIDE
You can solve many common appliance problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling a technician.
Problem
Appliance does not operate.
Appliance is not cold enough.
Turns on and off frequently.
The light does not work.
Vibrations.
The appliance seems to make too
much noise.
The door will not close
properly.
To contact out Authorized Service Center:
AGI SERVICE
Tel: 450.963.1303 / Toll free: 1.888.651.2534
Fax: 450.963.1416
Email:
customer@agintl.qc.ca
Possible cause
• Not plugged in.
• The appliance is turned off.
• Tripped circuit breaker or blown fuse.
• Check the temperature control setting.
• Due to external environment temperature, the unit may
require a higher setting.
• The door is opened too often.
• The door is not closed completely.
• The door gasket does not seal properly.
• The room temperature is higher than normal.
• A large amount of contents has been added to the
appliance.
• The door is opened too often.
• The door is not closed completely.
• The temperature control is not set correctly.
• The door gasket does not seal properly.
• Not plugged in.
• Tripped circuit breaker or blown fuse.
• The bulb has burned out.
• The light button is OFF – or the
button is on.
• Check to be sure the appliance is level.
• As each cycle ends, you may hear gurgling sounds caused
by the flow of refrigerant in your appliance.
• Contraction and expansion of the inside walls may cause
popping and crackling noises.
• The appliance is not level.
• The appliance is not level.
• The door was reversed and not properly re-installed.
• The gasket is dirty.
• The shelves are out of position.
26
Energy conservation
Publicité
