Rear Panel - Marantz professional PMD-500D Guide D'utilisation

Rear Panel

9
1. Audio Outputs (balanced, XLR): These outputs send the audio signal to your external speakers,
receiver, etc. Use XLR cables to make these connections.
2. Audio Outputs (unbalanced, RCA): These outputs send the audio signal to your external speakers,
receiver, etc. Use RCA cables to make these connections.
3. Composite Video Output: This output sends the video signal to your TV, display, etc. Use a standard
RCA composite video cable to make this connection.
4. Component Video Output: These outputs send the video signal to your TV, display, etc. Use standard
RCA component (Y/Pb/Pr) video cables to make these connections.
5. Coaxial Output: This output sends the digital audio signal to your TV. Use a standard coaxial cable to
make this connection.
6. HDMI Output: This output sends an HDMI audio and video signal from an external device. Use a
standard HDMI cable to make this connection.
7. Digital Optical Audio Output: This output sends the audio signal to your TV, receiver, etc. Use a
digital optical TOSLINK cable (IEC60958 Type II S/PDIF compatible) to make this connection.
8. Remote Input: This input lets you connect a host device (usually a computer) to PMD-500D. You can
use the host device to control PMD-500D via commands sent from it (using RS-232C serial
communication). Use a 9-pin D-Sub cable to make this connection.
Note: Visit marantzpro.com
9. AC In: Use the included power cable to connect this input to a power outlet.
See Setup > Connections
4
5
4
8
7
6
to download the serial protocol guide for PMD-500D.
for more information.
3 2
1