Rear Panel - Marantz professional PMD-526C Guide D'utilisation

Rear Panel

4
1. Outputs (unbalanced RCA): These outputs send the audio signals from a CD, SD, BT, or USB device (mass
storage class), and device connected to the Aux In. Use RCA cables to connect these outputs to external
speakers, sound system, etc. See
2. Outputs (balanced XLR): These outputs send the audio signals from a CD, SD, BT, or USB device (mass
storage class), and device connected to the Aux In. Use XLR cables to connect these outputs to external
speakers, sound system, etc. See
3. AC In: Use the included power cable to connect this input to a power outlet. See
4. Bluetooth Receiver: This is the built-in antenna used to receive a signal from a Bluetooth device.
5. Remote Input: This input lets you connect a host device (usually a computer) to PMD-526C. You can use the
host device to control PMD-526C via commands sent from it (using RS-232C serial communication).
Note: Go to marantzpro.com
6. Operation Switch: For standard playback, leave this switch at the "Normal" position. If updating the unit, set this
switch to the "Update" position.
Setup
Important: Connect all cables securely and properly (with stereo cables: left with left, right with right), and do not
bundle them with the power cable.
1. Use XLR cables or a stereo RCA cable to connect the Outputs (balanced or unbalanced) to the analog inputs of
your external receiver, amp, powered monitors, etc.
2. After completing all the connections, use the included power cable to connect the AC In to a power outlet.
Example:
SOURCE SELECT
ZONE 2 ZONE 2 ZONE 3 ZONE 3 INFO OPTION
ON/OFF SOURCE ON/OFF SOURCE STATUS DIMMER
ENTER VIDEO
PHONES BACK SETUP
AUX 1
HDMI 7 5V/1A
Receiver, amp, etc.
2
1
Setup for more information.
Setup for more information.
to access the serial protocol guide for more information.
MASTER VOLUME
QUICK SELECT
1 CBL/SAT 2 Blu-ray 3 GAME 4 NETWORK
L - AUDIO - R SETUP MIC
AUX 1
AV RECEIVER
5
6
Powered Monitors
3
Setup for more information.
Power
5