BorMann PRO BTC5105 Mode D'emploi page 9

EN
TROUBLESHOOTING
BEARINGS
The following bearings are sealed:
• Centrifugal clutch - grease lubricated
• Vibrator - oil bath lubricated
FINISH
The machine is finished in gold equipment enamel, the handle in black backed enamel. Exposed metal surface is zinc electroplated for corrosion protection.
Motor will not start
Motor stops
Petrol Motor lacks power.
Insufficient vibration
Machine is not moving freely
9
SYMPTOM
• Check the ON/OFF switch to ensure that it is switched "ON".
• Check the fuel supply.
• If a motor is fitted check the crankcase oil level as and oil
sensor device is fitted to these motors which prevents starting
and stops the motor when the oil level is low.
• Check the fuel supply.
• Check the condition of the air filter
• Check for a slipping or a missing see belt.
• Check the underside of the plate for a build up of material.
WWW.NIKOLAOUTOOLS.GR
POSSIBLE CAUSES AND CORRECTION