LENCO KCR-100 Guide D'utilisation page 12

No power
• Ensure that the mains cable is connected securely.
• Ensure that the unit is switched on.
The remote control does not function
• Use the remote control near to the unit.
• Point the remote control at the remote control sensor on the unit.
• Replace the batteries in the remote control with new ones.
• Remove any obstacles between the remote control and the unit.
The unit does not respond when pressing any buttons.
• In some situations the unit may freeze during use. To reset the unit, pull the plug from the mains socket, wait a few seconds and
then plug it in again.
No sound output
• Make sure that the unit is not muted.
I can't find the Bluetooth name of this unit on my Bluetooth device for Bluetooth pairing
• Ensure that the unit is switched on.
• Ensure that the Bluetooth function is activated on your Bluetooth device.
• The unit has a Bluetooth function that can receive a signal within 10 metres.
FM reception
• Ensure the antenna wire at the rear panel should be extended fully to improve the FM reception.
• Electrical interference in your home can cause poor reception. Move the unit away from them (especially those with motors and
transformers).
Interferences in Speakers
• Check that you have not left a mobile phone near the unit.
Trouble Shooting
12