Uline Classic Serie Mode D'emploi page 8

A B
Glide x 8 Metal Handle x 5 Sets
1. Insert glides (A) into bottom of pedestals.
(See Figure 23)
Figure 23
A
2. Turn upright. Remove pre-attached metal handle (B)
from inside of cabinet drawer by unscrewing with a
Phillips screwdriver. Move to the outside of drawer
and re-attach using same screws and a Phillips
screwdriver. (See Figure 24)
3. Attach file clips (C) to sides of drawers and insert
aluminum bars (D). (See Figure 24)
D
C
Figure 24
PAGE 8 OF 29
PEDESTAL ASSEMBLY PARTS
C
File Clip x 6
PEDESTAL ASSEMBLY
Tighten
Tighten
B
C
B
D E
Aluminum Bar x 3 Key x 2 Sets
4. Remove top drawer
by pressing down on
plastic tabs on drawer
slides and pulling out.
(See Figure 25)
5. Align pedestals to pre-drilled holes located on
underside of desk top. To attach pedestal to desk
top, insert M6 x 40 mm screws (F) from underside of
pedestal. For extra stability, use #4.5 x 1⁄" screws
(G) to attach pedestal to desk side panel.
(See Figure 26)
Figure 26
6. Replace top drawer by reconnecting drawer slides
and pushing in.
F
Screw x 8
M6 x 40 mm
Figure 25
F
G
Screw x 8
#4.5 x 1⁄"
Tab
F
0124 IH-5679