Uline Classic Serie Mode D'emploi

CLASSIC COLLECTION –
OFFICE DESK
TOOLS NEEDED
Phillips Screwdriver
Drill (optional)
A
Cam Lock Pin x 16
F
Screw x 35
#4 x 5/8"
NOTE: Assemble unit on a smooth, non-marring
surface to prevent scratching. Check that you
have all parts listed.
1. Insert cam locks (B) into back panel (1). Insert cam
lock pins (A) and dowels (C) into side panels
(2 and 3). Attach panels and tighten cam locks
using a Phillips screwdriver. Insert cam lock cap (I).
(See Figure 1)
Figure 1
A
C
2
1
I
B
3
PAGE 1 OF 29
1-800-295-5510
uline.com
Two Person Assembly
DESK SHELL ASSEMBLY PARTS
B
Cam Lock x 16
G
Grommet Cap x 2
DESK SHELL ASSEMBLY
2
1
Recommended
C
Dowel x 11
H
Deep Cam Lock
Cap x 7
IMPORTANT: Turn cam lock 1/4 turn to the right
to lock. Ensure the arrow is pointing toward side
edge of panel before inserting into the panel's
hole.
NOTE: Cam lock caps can be applied once
cam locks are tightened for a finished look.
2. Turn panels upside down. Insert cam locks (B) into
side panels (2 and 3). Insert cam lock pins (A) and
dowels (C) into top panel (4). Attach panels and
tighten cam locks using a Phillips screwdriver. Insert
deep cam lock cap (H). (See Figure 2)
B
C
H
4
Figure 2
Para Español, vea páginas 10-19.
Pour le français, consulter les pages 20-29.
D E
Glide x 4 L-Bracket x 5
I
Cam Lock Cap x 9
IMPORTANT: Function of Cam
1/4 Right Turn
for Locking
Ensure the arrow is pointing toward edge of
panel before inserting into the panel's hole.
3
1
A
4
2
3
0124 IH-5679