Uline Classic Serie Mode D'emploi page 4

A
Cam Lock
Pin x 14
1. Insert cam locks (B) into back panel (1). Insert cam
lock pins (A) and dowels (C) into side panels
(2 and 3). Attach panels and tighten cam locks
using a Phillips screwdriver. Insert cam lock cap (I).
(See Figure 8)
Figure 8
3
2. Insert cam locks (B) into side panels (2 and 3). Insert
cam lock pins (A) and dowels (C) into top panel (4).
Attach panels and tighten cam locks using a Phillips
screwdriver. Insert deep cam lock cap (H).
(See Figure 9)
Figure 9
1
4
2
PAGE 4 OF 29
CREDENZA SHELL ASSEMBLY PARTS
B
Cam Lock
x 14
F G
Screw x 35 Grommet
#4 x 5/8" Cap x 2
CREDENZA SHELL ASSEMBLY
2
1
A
C
2
1
I
B
Tighten
D
3
3
Tighten
E
3
F C
H
B
4
A
C D
Dowel x 11 Glide x 4
H
Deep Cam
Lock Cap x 5
3. Use L-Brackets (E) to connect back panel (1) and
top panel (4). Attach using #4 x 5/8" screws (F). For
additional stability, L-Brackets can be installed to
connect side panels (2 and 3) to top panel (4),
but only do so if pedestals will not be installed.
(See Figure 9)
4. Insert glides (D) into side panels (2 and 3).
(See Figure 9)
5. Insert grommet caps (G) into top and back panels.
(See Figure 10)
Figure 10
Proceed to U-Desk Bridge Assembly on page 5.
E
L-Bracket x 5
I
Cam Lock
Cap x 9
G
4
0124 IH-5679