Uline Classic Serie Mode D'emploi page 7

4. Remove paper backing and apply adhesive
strips (M) to bottom of hutch. (See Figure 17)
Figure 17
5. Move U-Desk to desired end location since
assembled desk is difficult to move. Carefully place
hutch onto the rear of the credenza. Attach flat
brackets (I) to the hutch and credenza using
#4 x 5/8" screws (H). (See Figure 18)
NOTE: Once cam locks are tightened, cam
lock caps (L) can be applied for a finished look.
Figure 18
6. Connect doors to hutch using center door hinges (D)
and side door hinges (E). (See Figure 19)
Figure 19
9
8
7
Tighten
PAGE 7 OF 29
U-DESK HUTCH ASSEMBLY CONTINUED
M
B
L
Tighten
I
H
10
D
7. Once door panels are attached, each hinge may
need to be adjusted to align the doors. To adjust
the depth of the doors, tighten or loosen the rear
screw in the hinge. To adjust the angle of the doors,
tighten or loosen the center screw in the hinge.
(See Figure 20)
Figure 20
Side
Panel
Door
Door Depth
8. Apply bumper plastic (J) to inside of doors to reduce
noise when closing. (See Figure 21)
Figure 21
9. Insert grommet cap (F) into back panel.
(See Figure 22)
Figure 22
Proceed to Pedestal Assembly on page 8.
Side
Panel
Door
Door Angle
J
F
0124 IH-5679