Panasonic Viera TC-L3232C Manuel D'utilisation page 12

First Time Setup
First time setup screen is displayed only when the TV is turned on for the first time after the power cord is
inserted into a wall outlet and when "Auto power on" (p. 34) is set to "No".
12
tc̲L3232c̲eng̲0608.indb 12 tc̲L3232c̲eng̲0608.indb 12
Turn the TV On with the POWER button
(TV)
or
or
Configure your viewing mode
Select your language
Language / Idioma / Langue
English Español Français
Select your viewing mode
Set viewing mode
Home Use Store Demonstration
OK
Select
RETURN
Please confirm your selection (Home Use) before pressing OK button.
If you select "Store Demonstration" by mistake in
confirmation screen will be displayed.
You are selecting the store demonstration mode.
Yes No
If you select "Yes", the picture mode will regularly reset
to "Vivid" and a Picture Refresh message will be displayed on the
screen.
Select "No" and return to previous screen
If you select "Yes", Screen enters the store demonstration mode.
To display the "Set viewing mode" screen again as shown above and select
"Home Use", do one of the following:
• Press and hold down the side POWER button for at least five seconds.
• Unplug power cord for 30 seconds and plug it again.
Note
If you use any other step other than
button to quit before completing the settings, the next time you turn the TV on, "First
time setup" will not be automatically displayed.
• The settings up to that point are saved.
• You can start "First time setup" at any time. (p. 34)
Language, ANT/Cable setup, Input labels, Clock can also be changed from the
Settings Menu. (p. 34)
(Remote)
select
OK
(Be sure to select "Home use")
Step 2 of 6
select
OK
select
OK
.
then turn the TV off, or if you used the EXIT
,
2010/12/24 13:40:09 2010/12/24 13:40:09