Makita HR5000 Manuel D'instructions page 5

CAUTION:
• Do not rotate the change lever when the tool is
running under load. The tool will be damaged.
• To avoid rapid wear on the mode change mech-
anism, be sure that the change lever is always
positively located in one of the two action mode
positions.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Side handle
Raise the side handle. The side handle can be secured
in four position (right, left, up and down). To secure
the side handle, tighten the clamp nut securely. Never
secure the side handle in other than the above four
positions.
1
2
► 1. Clamp nut 2. Side handle
Side grip
1
► 1. Side grip
The side grip is convenient for downward drilling or
chipping operations. Screw the side grip on the tool
securely. The side grip can be installed on either side of
the tool for right or left hand operation.
Installing or removing the bit
► 1. Tool holder 2. Tool retainer
Insert the bit into the tool holder as far as it will go. Pull
out and turn the tool retainer 180 degrees. Then release
it to secure the bit.
CAUTION:
• Never use A-type shank bits. They can cause
damage to the tool.
37
19
A
To remove the bit, follow the installation procedure in
reverse.
OPERATION
Hammer drilling operation
5 ENGLISH
1
2
180
27 38.5 37
19
B
16ø