Fracarro SIG7330 Instructions D'emploi page 23

There is the INPUT menù on detail:
TS INPUT – enables or disables the input of the Transport Stream from the back panel.
PRESET – it is possible to use the preset (through the function load preset) to help the programming (refer to the
paragraph 5.2 Preset list) – remember that the preset could not be correct due to modification from the broad-
caster.
LNB – To set the tone 0/22 KHz for band selection (High/Low) and the voltage 14/18 V to select the polarity.
DiSEqC – To set DiSEqC depending on the satellite (A, B, C o D).
FREQ.OL (MHz) – Read only value – it is visualized "AUTO".
FREQ.IF (MHz) – To set the IF frequency of the transponder to be received (it is necessary to know this value
before carry out the programming).
SYMBOL RATE – To set the symbol rate of the transponder which has to be received (it is necessary to know this
value before carry out the programming).
FEC – Read only value – it is visualized "AUTO".
SERVICE LIST – To visualize the list of available channels inside the selected transponder. Scrolling the channel
list with the TPE, it is possible to:
• Add a program to the channel list in decryption with the CAM (an asterisk "*" will appears on the second row
of the TPE for the selected program),
• Remove a program from the output channel list for the decryption.
• Show the selected program (the letter "S" will appears on the second row of the TPE for the selected pro-
gram). It is possible to select a program to encrypt.
SERVICE PROPR. – To know the available property for channels, in particular:
• The program name,
• The ID service of the selected program (sum of the three PID values), it is possible to increase or decrease
this value with the TPE arrows or insert a value using the TPE keypad.
• The PID PCR (Program Clock Reference) of the selected program,
• The PID VIDEO of the selected program,
• The PID AUDIO of the selected program (it is possible to select the available values with the TPE),
• The PID TELETEX of the selected program,
• The SUBTITLES, if they are available it will be possible to select their language with the TPE arrows,
• The CHANNEL TYPE (for example FTA, ENC, ...),
• The VIDEO FORMAT of the selected program (for example 4:3, 16:9, ...),
• The AUDIO TYPE IN, the audio type of the selected program (for example stereo).
23