Garland Roll&Comb 302E Manuel D'instructions page 27

Stoppage of the machine:
Let go of the On/Off switch (2).
6.6. CHECKING POINTS PRIOR TO USING THE
MACHINE
Check all the machine and make sure that there are
no loose parts (screws, nuts, knobs etc) and any
damages to the machine. Tighten, repair or replace all
necessary equipment prior to using the machine.
Check the state of the catcher and that it is properly in
place. Do not use the machine if it is damaged or not
properly regulated.
6.7. START UP AND STOPPAGE
Do not place hands or feet under the comber.
Maintain all body parts well clear from all
movingelements when the machine is in use.
After stopping the machine, the comber will not stop
inmediately. Wait until it has stopped before carrying
out any maintenance work on the machine or before
transporting the machine.
6. MACHINE USAGE
Use this machine only for those purposes for
which it has been designed. The usage of this
machine for any other purposes is dangerous and can
cause damages to the user and the machine.
Do not get anywhere near to the comber when the
machine is working.
If you lose your balance or fall, let go of the handle
switch immediately.
Do not solely rely on the security measures of this
machine. Use common sense at all times.
Do not use this machine if you are tired, sick, are
taking medicines, or if under the effect of alcohol or
drugs. Lack of sleep and fatigue can cause accidents
and damages.
Do not use this machine at night, with fog or with
reduced visibility. You must see the working area
clearly at all times.
Limit the usage of the machine to 10 minute stints
and rest for a further 10 to 20 minutes in between
sessions.
Never leave this machine unattended.
Do not allow anybody into the working area whilst the
machine is in use. The working perimeter is minimum
15 metres and this is the danger zone.
Clean and remove obstacles from the working area
that could cause accidents prior to use.
Do not use accessories on this machine except those
recommended by the manufacturer as otherwise the
use of non recommended accessories could cause
severe damages to the user and to the machine.
6.1. HOLDING AND GUIDING THE MACHINE
Whilst working, hold the machine firmly with both
hands on the handles.
Attention! Do not use the machine with
just one hand.
Attention! The machine can jump up or forwards
inadvertently, if the comber hit something hard that is
underground such as big stones, roots or trunks or if
the ground is too hard or if it is frozen. Always hold the
machine firmly with both hands.
27/100
English