Garland Roll&Comb 302E Manuel D'instructions page 26

English
5. START UP INSTRUCTIONS
5.1. LIST OF MATERIALS
This machine includes the following elements that you
will find inside the box:
• Machine
• Catcher
• Top handle
• Lower handle
• Screw for holding tubes
• Connecting wing nut
• Instruction manual
Remove carefully all the elements from the box and
make sure that all listed parts are included.
Due to the quality controls done at the factory it is
highly improbable that your machine has any faulty
part or that any elements are missing. If you find any
damaged part or there are any elements missing,
do not use the machine until the problem has been
solved or you have been given the missing parts.
Usage of the machine with defective or missing parts
is dangerous and could result in personal injuries.
5.2. MOUNTING THE MACHINE
1. Introduce the superior tube into the inferior tube
and connect using the screw and wing nut
provided.
2. Place the handle in the most comfortable working
position.
5.3 INSTALLATION OF THE CATCHER
Place the catcher (1) on the comber by hooking
the catcher on the hooks (2) on the rear part of the
machine. To do this, hold the catcher by the top
handle provided with your right hand.
2
5.4. CABLE FIXATION
Only use cable extensions
that are homologated for
outdoor use. The cable
section must be at least
1.5mm and the cable
extension should never be
longer than 25m and must
be completely unrolled
before starting to work.
Fix the extension of the machine by inserting cable in
the hook on the handle and plug onto the machine.
5.5. START UP AND STOPPAGE
Start up the machine:
Press the security button (1)
and without letting go, press
the On/Off switch (2).
26/100
1
1
2