Metrohm 799 GPT Titrino Mode D'emploi page 180

3.2. Remote control commands
176
The cycle number is set to 0 on switching on the instrument and it
is always incremented as long as the instrument remains
switched on.
.V: Volume
.Meas: Measured value associated to the cycle number.
The unit "assembly" must be preset (see 3.2.2.166).
3.2.2.168. Setup.SendMeas.Titrator.CyclNo
Setup.SendMeas.Titrator.V
Setup.SendMeas.Titrator.Meas
Setup.SendMeas.Titrator.dVdt
Setup.SendMeas.Titrator.dMeasdt
Setup.SendMeas.Titrator.dMeasdV
Setup.SendMeas.Titrator.ERC
Setup.SendMeas.Titrator.T
Selection of the values from the titrator which are sent in the set time interval
(see 3.2.2.165, formats see 3.2.2.144):
.CyclNo: Cycle number. Together with the cycle time (3.2.2.149), a time
frame can be set up. The other data belong to the corresponding
cycle number. The cycle number is set to 0 at the start of a
method and it is incremented until the end of the method.
.V: Volume.
.Meas: Measuring value with STAT, DOS, DOC with activated measured
value monitoring
.dVdt: associated volume drift.
.dMeasdt: associated measured value drift.
.dMeasdV: associated 1st derivative of the titration curve.
.ERC: ERC in DET.
.T: In STAT, DOS, DOC, with activated temperature monitoring.
The unit "titrator" must be preset (see 3.2.2.166).
3.2.2.169. Setup.AutoInfo.Status
Setup.AutoInfo.P
Setup.AutoInfo.T.R
Setup.AutoInfo.T.G
Setup.AutoInfo.T.GC
Setup.AutoInfo.T.S
Setup.AutoInfo.T.B
Setup.AutoInfo.T.F
Setup.AutoInfo.T.E
Setup.AutoInfo.T.H
Setup.AutoInfo.T.C
Setup.AutoInfo.T.O
Setup.AutoInfo.T.N
Setup.AutoInfo.T.Re
Setup.AutoInfo.T.Si
Setup.AutoInfo.T.M
Setup.AutoInfo.T.EP
Setup.AutoInfo.T.RC
Setup.AutoInfo.C.B1
Setup.AutoInfo.C.R1
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
799 GPT Titrino