Metrohm 799 GPT Titrino Mode D'emploi page 178

3.2. Remote control commands
174
L3 EOD (End Of Determination)
L4 Can be set in TIP
L5 Error
L6 Activate pulse + can be set in TIP
L7 Buret volume pulses
L8, 9 ---
L10-13 Monitoring in modes STAT, DOS, DOC
.ResetLines: Lines are set to the inactive status (= high).
3.2.2.158. Assembly.Stirrer
Switching stirrer ON/OFF.
3.2.2.159. Setup.Comport
Selects the Titrino COM for the output of automatic info:
&Setup.Keycode
&Setup.Trace
&Setup.SendMeas
&Setup.AutoInfo
3.2.2.160. Setup.Keycode
ON means the key code of a key pressed on the Titrino is outputted. The key
code comprises 2 ASCII characters; table of the keys with their code, see
page 195. A keystroke of key 11 is sent as follows:
#11
The beginning of the message is marked by a space (ASCII 32).
3.2.2.161. Setup.Tree.Short
Setup.Tree.ChangedOnly
Definition of the type of answer to $Q.
.Short: With "ON", each path is sent with only the necessary amount of
characters in order to be unequivocal (printed in bold in this manual). A com-
bination of .Short and .ChangedOnly is not possible.
.ChangedOnly: Sends only the changed values, i.e. values which have
been edited. All paths are sent absolute, i.e. from the root.
3.2.2.162. Setup.Trace
The Titrino automatically reports when a value has been confirmed with <en-
ter> at the Titrino. Message, e.g.:
&SmplData.OFFSilo.Id1"Trace"
The beginning of the message is marked by a space (ASCII 32).
3.2.2.163. Setup.Lock.Keyboard
Setup.Lock.Config
Setup.Lock.Parameter
Setup.Lock.SmplData
ON, OFF
1, 2, 1&2
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
799 GPT Titrino