Publicité
Les langues disponibles
Les langues disponibles
2 Name of parts
2 NAME OF PARTS
RPI-(16.0/20.0)FSN3PE
3 UNITS INSTALLATION
D A N G E R
•
Check to ensure that the accessories are packed with the
indoor unit.
•
Do not install the indoor units outdoors. If installed
outdoors, an electric hazard or electric leakage will occur.
•
Consider the air distribution from each indoor unit to the
space of the room, and select a suitable location so that
uniform air temperature in the room can be obtained.
•
Avoid obstacles which may hamper the air intake or the
air discharge flow.
•
Do not install the indoor units where electromagnetic
wave is directly radiated to the electrical box, remote con-
trol cable or remote control switch.
•
Prepare a steel box and install the remote control switch
in it. Prepare a steel conduit tube and wire the remote
control cable in it. Then connect the ground wire with the
box and tube.
Install a noise filter when the power supply emits harmful
•
noises.
•
This unit is exclusive non electrical heater type indoor
unit. It is prohibited to install a electrical heater in the
field.
•
Do not put any foreign material into the indoor unit and
check to ensure that none exist in the indoor unit before
the installation and test running. Otherwise a fire or failu-
re, etc., may occur.
3
PMML0323A rev.2 - 06/2014
C A U T I O N
Do not install the indoor units in a flammable environment to
•
avoid a fire or an explosion.
Check to ensure that the ceiling slab is strong enough. If not
•
strong enough, the indoor unit may fall down on you.
•
Do not install the indoor units, outdoor unit, remote control
switch and cable within approximately 3 meters of strong elec-
tromagnetic wave radiators such as medical equipment.
•
Do not install the indoor units in a machinery shop or kitchen
where vapor from oil or mist flows to the indoor units. The
oil will deposit on the heat exchanger, thereby reducing the
indoor unit performance, and may deform. In the worst case,
the oil damages the plastic parts of the indoor unit.
To avoid any corrosive action to the heat exchangers, do not
•
install the indoor units in an acid or alkaline environment.
When lifting or moving the indoor unit, use appropriate slings
•
to avoid damage and be careful not to damage the insulation
material on units surface.
Part Name
No.
1
Fan
2
Fan Motor
3
Heat Exchanger
4
Strainer
5
Wiring holes
6
Expansion Valve
7
Electrical Box
8
Refrigerant Gas Pipe
Refrigerant Liquid Pipe
9
10
Drain Pipe
11
Air Filter
12
Hook
13
Air Inlet
14
Air Outlet
15
Capacitor
16
Fan service cover
Publicité
