Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - Dual Integrated Installation
STEP 9 FINAL EXTERNAL UNIT PREPARATION
FOR FLUSH INSTALLATION:
of the door is 3/4" behind front face of surrounding
cabinets BEFORE securing brackets to the surrounding
cabinetry.
Open the doors to
the units. Locate
removal tool. Filter
should be as shown.
counterclockwise
tool if needed).
remove. NOTE: Water
system will not function
Predrill 1/16" holes is both the sides of the surround
1/2" deep through holes in the enclosure.
Secure unit by driving four 1/4" hex screws to both
sides to surrounding cabinetry. Use 90 degree tool
or alternate extension. NOTE: This step does NOT
replace the anti-tip safety hardware. Refer to Step
4 Installing Anti-Tip Bracket and Step 7 Inserting/
Securing into Cabinet Surround for details on installing
the anti-tip hardware. Repeat for the second unit.
1/4" Hex Screws
as shown.
hook.
Close the compartment door.
Put the access cover back onto the unit
and secure with two 1/4" hex head screws.
Access
Cover
31-1000731 Rev. 2
Make sure front surface
Compartment Door
Filter
Filter Removal
Tool
Mounting Hook
1/4" Hex Screws
On the side of the access cover that will face the middle
of the installation, drive two 1/4" hex head screws. These
screws will enhance attachment of mullion trim. Repeat on
the second access cover.
Access Cover
Hole Locations
the doors/drawers and push the flexible "dart" in the
area between units.
edge of the case trim. NOTE: Align dart correctly
before pressing in. Dart will be very difficult to move
once pressed in all the way.
covers.
55
Top
"Dart"
"Dart"
Mullion
Trim
NOTE: Doors/Drawers not
shown for clarity.
Publicité
