Cafe CXSB4H4PVBZ Instructions D'installation page 27

Installation Instructions - Single Integrated Installation
STEP 7 FINAL EXTERNAL UNIT
PREPARATION (Cont.)
Put the access cover back onto the unit and secure
with two 1/4" hex head screws.
Access
Cover
If installation requires a
limiter pin(s) must be installed
BEFORE the unit is removed from the shipping skid.
Pin is located in the hardware kit.
- Open the door to expose the hole in the back hinge
bracket and install the limiting pin. Pin must be
fully seated in the hinge or the door will not close
properly.
STEP 8 HANDLE INSTALLATION
Make sure the set screws in the handle caps are
loosened. Place the handle over the fasteners on
the door (we recommend putting the screw side of
the handle toward the less visible side). Take care to
support the handle so it doesn't fall and scratch the
appliance finish. Make sure both of the handle caps
are resting on the face of the door.
Fastener
31-1000731 Rev. 2
1/4" Hex
Screws
90° door opening, the hinge
in the top hinge(s)
Set Screw
STEP 8 HANDLE INSTALLATION
(Cont.)
Lock one end of the handle into position by tightening
the set screw in the handle cap with the 1/8" Allen
wrench. Be sure not to over tighten.
Keep supporting the handle as you lock the other
end of the handle into position by tightening the set
screw in the handle cap with the 1/8" Allen wrench.
Be sure not to over tighten.
Repeat these instructions on all other handles.
STEP 9 TOE KICK INSTALLATION
A stainless steel toe kick and a magnet are included
with the refrigerator.
Remove the toe kick magnet from the front access
cover.
Adhere magnet to back side of toe kick. The surface
of the toe kick where the magnet is to be placed
must be clean and free of foreign material. Center
magnet vertically and horizontally.
Position toe kick on bottom portion of the front
access cover.
STEP 10 INTERNAL UNIT
PREPARATION
Remove all tape, cardboard, and foam from the unit.
Remove boxed door bins from shelves.
Unbox and install door bins.
27