Publicité
Les langues disponibles
Les langues disponibles
How to Program to Brew Later
1. Follow steps 1 –8 in "How to
Brew Now" section. Press brew
later button. "19:99" will flash
and "
" will appear on
Display Panel when ready to
program.
NOTES:
• Do not move Shower Head until end of brew cycle after light in Water
Reservoir has turned off.
• To change previously set time, follow steps 1-3 again.
• Press back button ( ) to return to a previous step.
• If not using a charcoal water filter, use filtered or bottled water for
better-tasting coffee.
• Move Drip Stop to closed position ( ) at end of cycle, after light in
Water Reservoir has turned off. This prevent drips when Carafe is
removed.
2. Press and hold Select Button
to rapidly scroll though hours
and minutes. Once correct hour
or minute is displayed, setting
will flash for 4 seconds and be
confirmed.
3. Check to ensure following steps
are complete: add ground
coffee, move Drip Stop into
open position ( ), move Shower
Head above ground coffee, and
add water.
w CAUTION
Burn Hazard.
Position shower head over brew
basket before use.
• You can use same settings as your previous brew as long as power
has not been interrupted; press brew later button. Weigh the grounds
based on "Manual Pour-Over Coffee to Water Ratios" on page 11.
Then press back button and move Shower Head into position above
grounds. Add desired cups of water into Water Reservoir and set time
to start brewing.
4. Brew now and brew later
buttons flash alternately. Press
brew later button to hold
settings. "
" will illuminate
on Display Panel when Coffee
Maker is programmed to brew
later. To check time selected to
brew, press brew now or brew
later buttons, and time will
change to show set brew time.
9
Publicité
