Publicité
Les langues disponibles
Les langues disponibles
90559271 PC15TCS PC15TCSM CIR SAW.qxd:??????-00 Cir Saw book
LOWER BLADE GUARD
:
The lower blade guard is a safety feature which reduces the risk of
serious personal injury. Never use the saw if the lower guard is missing, damaged,
misassembled or not working properly. Do not rely on the lower blade guard to protect
you under all circumstances. Your safety depends on following all warnings and
precautions as well as proper operation of the saw. Check lower guard for proper
closing before each use as outlined in Additional Specific Safety Rules. If the lower
blade guard is missing or not working properly, have the saw serviced before using. To
assure product safety and reliability, repair, maintenance and adjustment should be
performed by an authorized service center or other qualified service organization,
always using identical replacement parts.
:
To reduce the risk of serious personal injury, read, understand and
follow all important safety warnings and instructions prior to using tool.
GENERAL CUTS (IMPORTANT: READ SAFETY WARNINGS AND INSTRUCTIONS. )
GUARD AGAINST KICKBACK
With unit unplugged, follow all assembly, adjustment and set up instructions.
Make sure lower guard operates. Select the proper blade for the material to be cut.
• Measure and mark work for cutting.
• Support and secure work properly (See Safety Rules and Instructions).
• Use appropriate and required safety equipment (See Safety Rules).
• Secure and maintain work area (See Safety Rules).
• With plug inserted and guard closed, make sure switch turns saw on and off.
:
It is important to support the work properly and to hold the saw firmly to
prevent loss of control which could cause personal injury. Figure E illustrates
recommended hand position.
ATTACHING AND REMOVING A RIP FENCE (NOT INCLUDED IN PC15TCS)
(FIGURE N)
A rip fence is used to saw in a straight line parallel
to the edge of the workpiece.
ATTACHING
• Insert the rip fence (18) through the openings in
the shoe (5).
• Slide the rip fence into the desired position.
• Screw in locking knob (19) and tighten.
REMOVING
• Loosen the locking knob (19).
• Pull the rip fence out of the tool.
NOTE: If you do not have a proper fitting fence, use
a straight edge guide in contact with the edge of the
shoe to improve accuracy of cut and reduce the
possibility of binding and kickback.
OPERATION
To reduce the risk of serious personal injury, turn tool off and disconnect tool from
power source before making any adjustments or removing/installing attachments or
accessories.
:
IMPORTANT: Always make sure the depth adjustment locking lever is
in the down position before operating saw.
SWITCH
• To operate the tool, depress the trigger switch (1) in figure A. The tool will continue to
run as long as the trigger is depressed.
• To turn the tool off, release the trigger switch (1). There is no provision for locking the
tool on, and the switch should never be locked on by any other means.
All manuals and user guides at all-guides.com
11
12/21/09
8:27 AM
N
19
Page 11
5
18
Publicité
