Publicité
Les langues disponibles
Les langues disponibles
90559271 PC15TCS PC15TCSM CIR SAW.qxd:??????-00 Cir Saw book
• Slide lever off the end of the nut, rotate the lever one position counter clockwise and slide
lever down onto nut.
• Reinstall flat washer, and reinstall retaining ring in groove on nut.
To tighten the levers for the PC15TCSM, follow the steps below:
• Remove retaining ring (shown in figure J2)
and thin flat washer. Retain for reassembly.
• Remove the lever and rotate the lever one
position counter clockwise and slide lever into
feature.
• Reinstall flat washer and lock ring with the
concave side against the lever.
KERF INDICATOR (FIGURE K)
The front of the saw shoe has a kerf indicator for
vertical and bevel cutting. This indicator enables
you to guide the saw along cutting lines penciled
on the material being cut. The indicator lines up
with the left (inner) side of the saw blade, which
makes the slot or "kerf" cut by the moving blade
fall to the right of the indicator.
Additionally, the PC15TCSM has 0 and 45 degree
visual indicators - the corresponding left and right
sides of the window in the rip fence slot (see item
13 in Fig. K), and also labeled 0 and 45 degree
indicators just in front of the blade kerf (see item
14 in Fig. K). Note that the upper guard has
been removed from Fig. K for clarity.
ATTACHING AND REMOVING THE BLADE
REMOVING THE BLADE (FIGURE L)
• Keep the spindle lock button (4) depressed and
rotate the blade until the spindle lock engages.
• Loosen and remove the blade retaining screw
(15) by turning it counterclockwise using the
wrench (9) supplied.
• Remove the outer washer (16).
• Remove the saw blade (6).
NOTE: Do not remove the inner washer (17)
in figure M.
ATTACHING THE BLADE (FIGURE M)
• Using the lower blade guard retracting lever,
retract the lower blade guard.
• Place the saw blade (6), on the spindle shaft,
making sure that the arrow on the blade points
in the same direction as the arrow on the tool.
Release lower guard lever.
• Fit the outer washer (16) on the spindle, with the
larger flat surface against the blade.
• Insert the blade retaining screw (15) into the
hole.
• Keep the spindle lock button (4) depressed.
• Securely tighten the blade retaining screw by
turning it clockwise using the wrench (9) supplied.
NOTE: The inner flange (17), should not be
removed. If it is removed, replace it as
shown in figure M.
All manuals and user guides at all-guides.com
10
12/21/09
8:27 AM
J2
PC15TCSM
K
14
14
L
4
9
15
16
M
16
15
Page 10
13
PC15TCSM
PC15TCS
17
6
Publicité
