Scheppach HWW1000 Traduction Des Instructions D'origine page 18

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws,
the manufacturer of the device does not assume
liability for damages to the product or damages
caused by the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized ser-
vice technicians,
• Installation and replacement of non-original
spare parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric reg-
ulations and VDE regulations 0100, DIN 57113
/ VDE0113.
We recommend:
Read through the complete text in the operating
instructions before installing and commissioning
the device.
The operating instructions are intended to help the
user to become familiar with the machine and take
advantage of its application possibilities in accord-
ance with the recommendations.
The operating instructions contain important in-
formation on how to operate the machine safely,
professionally and economically, how to avoid dan-
ger, costly repairs, reduce downtimes and how to
increase reliability and service life of the machine.
In addition to the safety regulations in the operat-
ing instructions, you have to meet the applicable
regulations that apply for the operation of the ma-
chine in your country. Keep the operating instruc-
tions package with the machine at all times and
store it in a plastic cover to protect it from dirt and
moisture.
18 | GB
Read the instruction manual each time before operat-
ing the machine and carefully follow its information.
The machine can only be operated by persons who
were instructed concerning the operation of the ma-
chine and who are informed about the associated dan-
gers.
The minimum age requirement must be complied with.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules for operating
woodworking machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description
1. Pressure connection
2. Transport handle
3. Tank
4. Bracket for screws
5. Water drain plug
6. Manometer
7. Suction connection
8. Screw-on pre-filter cap
9. Pre-filter
10. Valve cover
11. Valve
12. On/off switch
3. Scope of delivery
• Operating manual
• House water system
4. Intended use
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufactur-
er will be liable for any damage or injuries of any kind
caused as a result of this. To use the equipment prop-
erly you must also observe the safety information, the
assembly instructions and the operating instructions
to be found in this manual. All persons who use and
service the equipment have to be acquainted with this
manual and must be informed about the equipment's
potential hazards. It is also imperative to observe the
accident prevention regulations in force in your area.
The same applies for the general rules of health and
safety at work.
www.scheppach.com