Scan Function; Manual Rotation; Automatic Drift System - Kapro PROLASER ELECTROTA GREEN Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Scan Function

The Scan function is used to limit the area covered by the laser
beam, for safety reasons or to improve visibility and sensitivity.
A smaller scan segment will be more visible than a larger one.
The default mode is a 360° rotation, which provides a
horizontal or inclined beam throughout the work area or room.
The scan button changes the mode from a 360° rotation to a
0° 10° 45° 90° 180° scanning. Press the scan button
until the laser is set at the desired scan mode. The scan mark
can then be accurately positioned using the clockwise and
counterclockwise rotation controls.

Manual Rotation

When the laser beam is at 0° rpm or in scan mode you can
manually rotate the beam using Rotation left and Rotation right
keys.

Automatic Drift System

Use this function to prevent misaligning the laser level while in
automatic mode.
Press the Automatic drift system key after turning the laser
level on automatic mode. The LED indicator, near the key, will
flash, and automatic drift system will turn on. The laser level
will not re-level itself or spin again after any displacement while
on automatic mode. If the laser level does not rotate while the
LED indicator near the Automatic drift system key flashes more
frequently, then the level was shifted during its operation.
Check the position of the laser beam and readjust it, if needed,
before turning it on again. Disengage the automatic drift system,
check / readjust the position of the device and turn it on again.
14

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

8991g

Table des Matières