Samsung NX58H5600S Serie Mode D'emploi page 61

to lubricate the slides
1. Remove the rack from the oven. See removing
the gliding rack in the USING THE GLIDING
RACK section.
2. Fully extend the rack on a table or countertop.
Newspaper may be placed underneath the rack
for easy cleanup.
3. If there is debris in the slide tracks, wipe it away
using a paper towel.(Any graphite lubricant
wiped away must be replaced - See steps 4
through 7.
4. Shake the graphite lubricant before opening
it. Starting with the left (front and back) slide
mechanism of the rack, place four (4) small
drops of lubricant on the two (2) bottom tracks
of the slide close to the bearing carriers.
5. Repeat for the right (front and back) slide
mechanism of the rack.
6. Open and close the rack several times to
distribute the lubricant.
7. Replace the cap on the lubricant and shake it
again. Turn the rack over and repeat steps 3, 4,
5 and 6.
8. Close the rack, turn rack right-side-up and place
in the oven. See installing the gliding rack in the
USING THE GLIDING RACK section.
•
WEB_NX58H5 Series_AA_DG68-01006A-00_EN+MES+CFR.indb 61
Do not spray the gliding rack with
cooking spray or other lubricant sprays.
3
4
4
5
5
maintaining your appliance _61
2017-08-24 11:43:36